Call (480) 985-9279

Jeep

/Jeep

We Service and Repair Most Jeep Cars and Trucks

2007 Jeep Wrangler

2020-04-01T22:01:20+00:00

Jeep Wrangler

Mileage
64,163
Service Date
3/31/2020
Services Performed
  • Confirmed broken glass on the mirror.
  • Loosened bolts and pivots bracket to allow bolt installation.
  • No aftermarket options available – will require custom made piece
  • Remove fasteners and replace the mirror. Install the blind spot mirror into the left corner of the new assembly.
  • Remove stabilizers and install new units with new brackets.
  • Remove the brake calipers and brackets. Disconnect the speed sensors. Remove wheel bearings with the axles. Remove both spindles and replace the upper ball joints. Reassemble and test drive the vehicle.
  • Remove the fasteners and differential cover plate. Clean surfaces, install new sealer and reassemble. Fill with fluid and inspect for leakage.
  • Remove the stabilizer shocks. Remove the tie rod nuts and discard the toebar assembly. Install the new unit and reassemble with new stabilizer.
  • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel and adjust steering angle as needed.
  • Test drove the vehicle and a slight wander could be felt. Inspected the front suspension and found toe bar to be bent. Inspected alignment and camber is excessively negative on both sides with toe being almost a degree out. Recommend new toe bar and offset upper ball joints.
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
 
Nate J. gave our service a 5 star review on 3/31/2020
2007 Jeep Wrangler 2020-04-01T22:01:20+00:00

2014 Jeep Grand Cherokee

2020-03-23T22:00:32+00:00

Jeep Grand Cherokee

Mileage
115,462
Service Date
3/20/2020
Services Performed
  • Competed Inspection on Tablet
  • Install oil system cleaner. Road test vehicle. Change oil and filter. Add BG MOAto oil system. Rotate tires as needed. Lubricate chassis as needed. Perform Vehicle inspection. Adjust tire pressure. Fill windshield washer fluid. Lubricate latches and hinges.
  • Replace left front marker bulb
 
Andrew W. gave our service a 5 star review on 3/22/2020
2014 Jeep Grand Cherokee 2020-03-23T22:00:32+00:00

2015 Jeep Wrangler

2020-03-11T22:02:28+00:00

Jeep Wrangler

Mileage
35,696
Service Date
3/10/2020
Services Performed
  • Completed inspection on tablet.
  • Inspect for possible coolant smell intermit after hot
  • Install oil system cleaner. Road test vehicle. Change oil and filter. Add BG MOAto oil system. Rotate tires as needed. Lubricate chassis as needed. Perform Vehicle inspection. Adjust tire pressure. Fill windshield washer fluid. Lubricate latches and hinges.
  • left mirror does not work from switch. tested power to door connector. power present. recommend new mirror.
  • removed drivers door panel. removed wiring from door. removed mirror and installed new part. connected wiring. tested mirror operation. installed door panel.
 
Michael M. gave our service a 5 star review on 3/10/2020
2015 Jeep Wrangler 2020-03-11T22:02:28+00:00

2013 Jeep Grand Cherokee

2020-03-02T23:00:36+00:00

Jeep Grand Cherokee

Mileage
73,403
Service Date
2/26/2020
Services Performed
  • Road test vehicle. Change oil and oil filter. Rotate tires as needed. Lubricate chassis as needed. Perform Vehicle inspection. Adjust tire pressure. Fill windshield washer fluid.
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
 
Bill G. gave our service a 5 star review on 3/1/2020
2013 Jeep Grand Cherokee 2020-03-02T23:00:36+00:00

2012 Jeep Liberty

2019-11-02T22:00:46+00:00

Jeep Liberty

Mileage
102,520
Service Date
10/31/2019
Services Performed
  • Client reports intermit no crank no start – seems as if turn key lightly it happens more frequently, if turn key with more authority it will start – advise
  • Completed inspection on tablet.
  • Gain access to cabin filter housing. Remove cover and filter. Clean out debris. Apply BG frigi-fresh to new filter and install new filter back in housing.
  • Inspect hoses and clamps. Add cleaner to coolant and run through engine, radiator, and heater core. Installed coolant flush machine in-line to coolant system. Pulled vacuum on system to remove old coolant. Pushed 3 gallons of new coolant through cooling system. Add conditioner and sealant to system. Check thermostat and electric cooling fan operation. Test drive and verify proper operation of cooling system.
 
Terry A. gave our service a 5 star review on 11/1/2019
2012 Jeep Liberty 2019-11-02T22:00:46+00:00

2010 Jeep Wrangler

2019-10-21T22:01:09+00:00

Jeep Wrangler

Mileage
19,804
Service Date
10/15/2019
Services Performed
  • Competed Inspection on Tablet
  • Pressure tested system and found coolant leaking passed lower hose clamp. Tightened all clamps on the radiator hoses and no more leaks are seen.
  • Removed wheels from vehicle. Computer spin balanced all wheels. Installed wheels on vehicle and torqued lug nuts to manufacturer's specifications. Test drove to verify proper operation.
  • Test drove vehicle and noticed steering wheel wobble at 40 MPH. Inspected the suspension and no issues evident. Inspected tires and found the fronts are severely chopped. Balanced and rotated the tires. Performed additional test drive and the vibration is no longer present.
 
Christine S. gave our service a 5 star review on 10/20/2019
2010 Jeep Wrangler 2019-10-21T22:01:09+00:00

2015 Jeep Wrangler

2019-09-14T22:03:32+00:00

Jeep Wrangler

Mileage
32,793
Service Date
9/13/2019
Services Performed
  • Client reports bad wobble from front end when hit a bump at 40-50mph, or when on rough road – advise – refer to hist
  • Client reports driver door power mirror inop – advise – refer to hist
  • Client reports loud clicking noise when put transfer case in 4wd – advise
  • Gain access to cabin filter housing. Remove cover and filter. Clean out debris. Apply BG frigi-fresh to new filter and install new filter back in housing.
  • Inspect hoses and clamps. Add cleaner to coolant and run through engine, radiator, and heater core. Installed coolant flush machine in-line to coolant system. Pulled vacuum on system to remove old coolant. Pushed 3 gallons of new coolant through cooling system. Add conditioner and sealant to system. Check thermostat and electric cooling fan operation. Test drive and verify proper operation of cooling system.
  • Remove both upper arms. Remove the bushings and press in new parts. Reattach the arms to the front differential.
  • Remove fasteners from the front driveline and remove. Send out for repair. Install the driveline, test drive and verify repair.
  • Remove front wheels, brakes and tie rods. Remove bearings and axles. Remove both front spindles. Press out the ball joints and install new units. Reassemble the spindles, axles and brakes.
  • Removed wheels from vehicle. Computer spin balanced all wheels. Installed wheels on vehicle and torqued lug nuts to manufacturer's specifications. Test drove to verify proper operation.
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
  • Repair front driveshaft-99223
 
Michael M. gave our service a 5 star review on 9/13/2019
2015 Jeep Wrangler 2019-09-14T22:03:32+00:00

2012 Jeep Wrangler

2019-08-09T22:00:17+00:00

Jeep Wrangler

Mileage
55,884
Service Date
8/5/2019
Services Performed
  • Install oil system cleaner. Road test vehicle. Change oil and filter. Add BG MOAto oil system. Rotate tires as needed. Lubricate chassis as needed. Perform Vehicle inspection. Adjust tire pressure. Fill windshield washer fluid. Lubricate latches and hinges.
  • Noise it's coming from the starter due to starter being stuck out
  • Cause of abs light was most likely due to steering wheel being off center. Recommend clearing codes and going from there. Also found steer rod is bent recommend replacing steer rod as well
  • Service supercharger – replace oil
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
  • Disconnected battery. Raise the vehicle in the air disconnected power wire and Signal wire. Unbolted starter and installed new starter test drove vehicle everything is good at this time.
  • Accessed air box. Removed and replaced engine air filter. Cleaned excess debris form air box. Secured air box. Accessed cabin filter and removed. Sprayed BG Frigifresh on new filter and installed new cabin filter.
 
Ruston R. gave our service a 5 star review on 8/8/2019
2012 Jeep Wrangler 2019-08-09T22:00:17+00:00

2012 Jeep Liberty

2019-03-24T22:01:05+00:00

Jeep Liberty

Mileage
97,070
Service Date
3/22/2019
Services Performed
  • was not able to duplicate customer concern at this time , did find worn out suspension parts . rec lower control arms and front struts . struts are original and lower ball joints have excessive play , also lower control arm bushing cracked .
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
  • removed old front lower control arms and replaced with new , removed front strut assembly and replaced with new torqued all bolts to spec and double checked all work .
  • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel and adjust steering angle as needed.
  • Add cleaner to transmission. Test drive to verify operation and circulate cleaner. Use fluid exhnage machine to remove old fluid and add new. Add fluid conditioner and verify proper level. Test drive to verify proper operation.
  • Reseal leaking transmission pan
  • removed old spark plugs and replaced with new .
  • Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders if applicable. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Test drove to verify proper brake operation.
 
Terry A. gave our service a 5 star review on 3/23/2019
2012 Jeep Liberty 2019-03-24T22:01:05+00:00