- Remove fan clutch and drive belt. Remove fasteners and discard water pump. Clean surface, install new unit and reassemble. Fill cooling system, test drive and inspect repair.
- Remove the filler neck housing and tailgate. Remove bed fasteners and lift up on the driver side. Disconnect fuel line and harness. Remove lock ring and fuel pump. Install new seal and pump module. Reassemble, start engine and inspect for leaks.
- Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
- Truck bed was lifted up to inspect. Found pressure line spout to be cracked. Installed a new pump and verified fuel is not leaking. Test drove and check engine light is on for a P0499 (leak detection pump high voltage) and will not clear.
Hector S. gave our service a 5 star review on 4/30/2020